Pligun Fast Track 80
Product: Pligun Fast Track 80
Product #: 3253
Service Temperature Limit: 3100°F
Installation Method: Gunning
Shelf Life: 9 months
Industries: Mineral Processing, Power Generation, Oil/Gas, Off-Gas
Best Applications: Typical application s include:
- Circulating Fluidized Bed (CFB) boilers – cyclones, downcomers, and hoods
- Sulfur Recovery Units (SRU) – transition section and burner chamber
- Thermal Oxidizers – combustion and quench chambers
- Waste Incinerators – primary combustion chamber
- Rotary Incinerators – secondary combustion chamber
- Alumina and mineral calciners – high abrasion areas
Plibrico TDS Link – https://plibri.co/4l540xd
Product Information: Pligun Fast Track 80 is a high performance 80% alumina, low cement gun mix. This product was designed as a primary lining material for demanding applications requiring abrasion resistance and high strength both hot and cold. Cure times after installation can be reduced to 4 hrs, however for ideal physical characteristics 8 hrs is recommended. After curing, initial heating can be as fast as 100°F/hr with no temperature holds. Please refer to Plibrico Bake Out Schedule FT for specifics. Product advantages include:
- Excellent abrasion resistance – below 10cc loss per ASTM C704
- High cold crushing strength – greater than 8000 psi
- Very good hot MOR up through and beyond 2000°F
- Good alkali / slag resistance
Available Internationally As: Plico® Gun Mix Fast Track 80
Plibrico SDS Link – https://plibri.co/4rckW6x